Kia Telluride Tire Pressure
Most Kia Telluride models use 33–35 PSI in the front and 33–35 PSI in the rear, depending on model year and tire size.
Recommended Tire Pressure (Cold)
Always check on cold tires (parked 3+ hours). Verify on driver-side door jamb sticker.
All data is for informational purposes only. Always refer to your vehicle's owner's manual for the correct tire pressure.
Tire Pressure by Tire Size
| Tire Size | Front PSI | Rear PSI |
|---|---|---|
| 245/60R18 | 35 | 35 |
Tire Pressure by Model Year
Select your Kia Telluride model year to see the exact tire pressure specifications for that year, including any tire-size-specific variations.
How to Reset the TPMS Light on a Kia Telluride
- Inflate all four tires to the recommended cold PSI (shown above and on the driver-side door jamb sticker).
- Drive the vehicle above 25 mph for at least 10 minutes. The TPMS receiver typically re-learns the sensor pressure during this drive cycle.
- If the light remains on, with the vehicle parked and the ignition ON (engine off), locate the TPMS reset button — on most Kia Telluride models it is below the steering wheel or inside the glove box.
- Press and hold the TPMS reset button until the tire pressure indicator blinks three times, then release.
- Start the engine and wait a few minutes for the new baseline pressure to register.
If the light returns after a reset, re-check cold PSI on all four tires plus the spare, then inspect for a slow leak. Persistent warnings usually mean a faulty TPMS sensor (typical replacement cost: $50–$100 per wheel at an independent shop).
Frequently Asked Questions
What is the recommended tire pressure for a Kia Telluride?
The recommended cold tire pressure for the Kia Telluride varies by model year and tire size. Front PSI ranges from 33 to 35, and rear PSI ranges from 33 to 35, measured cold. Check the year table below for your specific model year, then verify against the driver-side door jamb sticker.
How do I reset the TPMS light on a Kia Telluride?
After inflating to the recommended PSI, drive above 25 mph for 10+ minutes. If the light stays on, locate the TPMS reset button (typically below the steering wheel) and hold it until the indicator blinks three times. The receiver usually re-registers the new baseline on the next drive cycle.
Does the Kia Telluride have a separate tire pressure for a performance or hybrid trim?
No — the recommended cold PSI is the same across every Kia Telluride configuration on the standard tire size (245/60R18). Performance trims, when equipped with wider tires, may list a different PSI in the tire-size table above.
Why does my Kia Telluride tire pressure read higher than 35 PSI after driving?
Driving heats the tires and raises the PSI reading by 2–4 PSI. The 35 PSI recommendation is a cold pressure measured before driving or after at least 3 hours parked. Never deflate to 35 PSI after driving — you'll end up under-inflated once the tires cool.
What happens if my Kia Telluride tire pressure is too low?
Under-inflated tires increase rolling resistance, reducing fuel efficiency by up to 3%. They wear faster on the outer edges, generate excess heat that can cause blowouts at highway speeds, and reduce braking and handling performance. If your TPMS warning light is on, check your tire pressure as soon as possible.
Need a reliable tire pressure gauge? See our guide to the best tire pressure gauges →